ONE Boomerangs Whirlwind


#boomerangs #boomerangsforsale #australia #australianboomerang #returningboomerangs

Comments

Post a Comment

Popular posts from this blog

Why I Choose Plastic for Boomerang Making

Image
Well, when I first started making boomerangs I could see it was a hard task, not only was good quality plywood hard to find but if you did find some it cost The earth to buy, I did try a wide variety of plywood, everything from Queensland maple, Hoop pine, Meranti and Finish birch, all reasonable quality but I couldn't find any consistency from sheet to sheet, the grain varied a lot and the density was always different and not consistent, this doesn't help repeat ability when making boomerangs. I like the fact to that plastic is incredibly easy to tune without breaking, especially polypropylene. Then I had a bright spark, what about I use plastic, not only is it consistent in density but it's easily available and there is a diverse range of plastic that are more readily up the the job, polypropyle was available just down the road from where I lived, this was great, the only one that seemed hard to get was phenolic but a few phone calls sorted that out and I c...
Read more

You Save On Performance Boomerangs

Image
ByI have decided to make my boomerangs at extremely affordable prices, same performance as always, the only difference now is they are no fuss finishes, this means you save and still have a high performance boomerang that is more than capable of making you a winner in competition or recreation, visit ONE Boomerangs   to find the boomerang that suits you. www.competitionboomerangs.com www.adamcarrollboomerangs.com www.realboomerangs.com
Read more

Boomerang Designs Revisited

Image
On the weekend I received a boomerang order, the order was for boomerangs that weren't in the Catalog but we're from a time when I made them in the past, I was happy to oblige as they were great designs that weren't popular from a sales point, I'm not sure why as they have so much potential for competition, anyway I went down to my workshop and got stuck into cutting and shaping, I revised the airfoil to make them even better than before, I went and tested them in the park and they were fantastic flyers, both a ton of fun and super accurate.  The improvements were so good I will be putting them back in the Catalog shortly, I am very happy to say the least.  The two designs are the Blast and the Cyclone, the Blast is a 50m triblader, tiny and compact, it likes a bit of wind, totally mesmerising in flight, the Cyclone is a multi purpose boomerang, it's best suited to accuracy, endurance or team relay, again lovely flight and dead on accuracy.  I feel I have breathed n...
Read more